Spacelog Apollo 13

Well, if I—If I get everything done, I'll try, but I tell you, it's almost impossible to sleep. All of us have that same problem. It's just too cold to sleep.

Roger. The way we're looking at it, looks like you ought to have a couple 3 hours here before you have to really get with it.

We'll—we'll take it easy, but I—and we'll try to sleep, but it's just awful cold.

Present data indicates that your entry angle is minus 6.03 degrees. Your DELTA-V at the midcourse is going to 2.8 feet a second.

Okay. Copy.

Jack, this is Jim. I understand this is going to be an RCS burn.

That's affirmative, Jim. It's going to be an RCS burn.

Okay.

And we need the SUIT CIRCUIT RELIEF valve back to AUTO. Correction, back to CLOSE.

Hey, Jack, that's in work. And one thing, comparing Jim's checklist with my own, I find one difference there at EI minus 02:30. His checklist has me changing a—opening a EPS SENSOR SIGNAL circuit breaker right prior to turning off LM power. Is—I'd like to find out which checklist is correct.

Hey, Jack. The LM checklist is just for information to Jim. It's just to tell him that—that you're changing back to command module power. Your checklist is correct. Over.

Aquarius, all of your pads will be coming up in about 3-1/2 hours, at EI minus 06:30. And one thing we want to remind you of, when you remove power from the command module LM umbilical, is to be sure that you open the LM POWER MAIN B circuit breakers, both of them, before you start throwing switches and circuit breakers in the LM. Do it as we've outlined it in the procedure, in that order. Over.

Okay. That's the way we planned on it. We'll let Jack do his three and then he'll tell us when we're GO from there. What pages are those changes on?

Okay, Fred. The one I've got for you is at the end of power removal from the command module LM umbilical. And just for your information, after you go through that entire procedure and about the time you're ready to transfer to the command module, at that time, power will be removed from the umbilical, and it's okay to disconnect it. That is, after you've thrown the switches in the LM. Is that clear?

Roger. That's where I've got a remark here to check with you to see if it's all right to proceed.

Roger. And that would be just after, on panel 16, you opening ASCENT ECA CONTROL breakers.

Which step number is that?

The confusing thing is, Jack, where they told me to wait for MSFN GO before proceeding was that BAT 2 LOW VOLTS OFF/RESET, then ON.

Okay. That's still affirmative. We'll give you a go after waiting 5 seconds, and then down from there just a few steps, after you have opened the ASCENT ECA CONTROL breakers on panel 16, at that point, the umbilical is not powered, and it's okay to disconnect them should you care to do so.

Okay. After the last step then, I'm free to disconnect.

Right. And one other change we have is, shortly after that, where we're configuring for jettison, we have closed both the FORWARD DUMP valve and the OVERHEAD DUMP valve. And we don't want to get in a locked up position like that, so one way to get around it is to—After we close the FORWARD DUMP valve, turn the DESCENT OXYGEN valve off. Over.

Okay. After the FORWARD DUMP valve, add a step in that says the DESCENT OX valve, off.

Okay, Fred. That concludes the DELTAs. And perhaps you heard that our GAMMAs are still minus 6.03 and our DELTA-V will be a 2.8-foot-per-second RCS burn.

Roger.

Fred-o, we've got one more change we'd like to give you to clarify a question that Jack asked earlier. At EI minus 02:30 —

Okay. Hold on a minute, Jack. I meant to call Jack back down. I'm not familiar with the previous discussion.

Negative. This is on your checklist.

Okay. Go ahead.

At E mi—EI minus 02:30, during power removal from the umbilical, first thing we do is two steps with the CSM. We open the MAIN B, the LM POWER to MAIN B circuit breakers, and then there's a third step which says “Circuit breaker EPS SENSOR SIGNAL, MAIN B, open.” Just delete that step. Over.

Okay. Delete the third step.

I concur. I think for reentry we don't have to have a real accurate platform, but I haven't told Jack that.

Roger. Hey, Jim, while you're up and things are nice and quiet, let me give you a couple of other things to think about. One specifically. I know none of you are sleeping worth a damn because it's so cold, and you might want to dig out the medical kit there around 01:35 or in that ballpark, and pull out a couple of Dexedrines apiece and try one about then, and another around 01:39 to 01:40.

Well, I hadn't brought that up. We might—We might consider it.

Okay.

Wish we could figure a way to get a hot cup of coffee up to you. It'd probably taste pretty good about now, wouldn't it?

Yes, it sure would. You don't realize how cold this thing becomes when it's in a PTC mode that's slowing down, and I just clocked the cycles on my … And it's about 11 to 12 minutes now, and the Sun is directly overhead, so it's shining on the engine bell of the service module and not getting down to the spacecraft at all.

Hang in there. It won't be long now.

Aquarius, Houston.

Go ahead, Houston.

Okay, Skipper. We figured out a way for you to keep warm. We decided to start powering you up now, and what we want you to do—what we want you to do is take your entry LM PREP checklist and start at the top where it says “BAT 5 NORMAL FEED on,” and then jump over as it says to your 30-minute activation, and do all of the 30-minute activation up to, but not including, the burn. You copy?