- Vance Brand (CAPCOM)
-
Right. Okay. At the top of the page, under step 4, just above “VHF/S-band activation,” put in, “Delete POWER AMP and LGC.” These are caution lights.
- Vance Brand (CAPCOM)
-
Okay. Under “VHF/S-band activation and checkout,” step 2, we have changes to the COMM as fellows.
- Vance Brand (CAPCOM)
-
Okay. Scratch—Scratch out the DOWN and DOWN VOICE. That leaves—That'll give you VOICE.
- Vance Brand (CAPCOM)
-
Okay. Under “PGNS turn-on,” add in steps 1 and 2 again, which are NO ATTITUDE light off, VERB 96 ENTER, and set EVENT TIMER.
- Vance Brand (CAPCOM)
-
That's affirm. And underneath “Set EVENT TIMER,” add the following: VERB 25 NOUN 07, ENTER; 1257, ENTER.
- Fred Haise (LMP)
-
Okay. After event, set EVENT TIMER, it's VERB 25 NOUN 07, ENTER; 1257, ENTER; 252 ENTER; ENTER.
- Vance Brand (CAPCOM)
-
Okay. Next, same page, under “DAP set gimbal drive,” go to step 2. Okay. Add in after NOUN 46, 32021.
- Vance Brand (CAPCOM)
-
Okay. Proceeding on down below the NOUN 47, to the PROCEED, insert VERB 34, ENTER, after the PROCEED. And that would come before the NOUN 48.
- Vance Brand (CAPCOM)
-
Okay. At the very first step above “GUIDANCE CONTROL, AGS,” put in VERB 76, ENTER.
- Vance Brand (CAPCOM)
-
Okay. Below “GUIDANCE CONTROL, AGS,” the third step should be changed to be MODE CONTROL, both, to ATT HOLD.
- Fred Haise (LMP)
-
Okay.
Expand selection down Contract selection up - Vance Brand (CAPCOM)
-
Okay. At minus 6—6 hours—or 6 minutes rather, under MODE CONTROL, PGNS, ATT HOLD, which was scratched out, insert VERB 41 NOUN 20, ENTER, and three more ENTERs. So—So it's as shown in your procedure there.
Spoken on April 17, 1970, 4:28 a.m. UTC (54 years, 6 months ago). Link to this transcript range is: Tweet