- Jim Lovell (CDR)
-
This is the LM to command module transfer, and this is the Delta from the launch stowage. Number 1: DSEA …; number 2: LM flight data file in R-1, R-2, R-3; three PPKs in A-8 … -
- Vance Brand (CAPCOM)
-
Okay, that's affirm, Jim. We had a lot of noise, and we didn't get the middle part, but I think that's fairly—should be fairly clear to you, and don't bother with the readback of that that we missed, unless you have any doubts. And then I'll, if you're ready to copy, I'll give you the second list.
- Vance Brand (CAPCOM)
-
Okay. This is CM to LM equipment transfer. Cabin fan filter and bag, and that, in the LM, should go in the ISA. Okay, next: decontamination bags, except for the ones used to wrap camera, should go in the ISA.
- Vance Brand (CAPCOM)
-
Okay. Two LCGs, if you don't have them on already, to the IS—ISA. I realize you wouldn't have them on, because you're cold enough already.
- Vance Brand (CAPCOM)
-
Okay, and finally, four LiOH cans, the ones used in the LM, and those can go in the jettison bag in the LM. Okay, a couple of notes. After loading the ISA, recommend secure it to the righthand restraint system.
- Jim Lovell (CDR)
-
Okay, Vance. This is command module to LM: cabin fan filter and bag in the ISA; decontamination bags, except for the ones we use for the TV camera, in the ISA; two LCGs in the ISA; four LOiH [sic] cans in the JETT bag; and we'll secure the ISA on the right-hand side—on the right-hand restraint system, and we'll secure the JETT bags to the PLSS on the floor.
- Vance Brand (CAPCOM)
-
Jim, would you give us PCM to HI bit rate. We think maybe we might be able to lock up on your high bit rate now. Over.
- Vance Brand (CAPCOM)
-
Okay, Jim. We're getting it intermittently. We think we might get it steady and improve circuit margins if you would, in addition, on panel 16, open the PRIMARY POWER AMPL circuit breaker, and I'll give you next step in a minute.
- Vance Brand (CAPCOM)
-
Or rather, Houston. Jim, it looks like we got a lockon, which is going to improve our data flow here. Only thing is, we'll probably lose data and probably voice, too, during a portion of each roll. So you might expect that. The other thing is, if anyone has on any BIOMED, would you switch your switch to—your BIOMED switch to that position.
- Jim Lovell (CDR)
-
— Fred and Jack are maneuvering things around right now, and mine is long since departed the scene.
- Jim Lovell (CDR)
-
Vance, you might be interested—the way we're—the way we got this thing arranged, we have one helmet attached to the COMM lines attached to the LM hoses, and the guy that's got the duty wears the helmet, so the other people are free to maneuver.
- Vance Brand (CAPCOM)
-
Jim, when you get finished moving your stowage around and it's convenient, we'd like to terminate the battery charge for a little while to bring up the CM TM so we can take a look at the temperatures again, like we did yesterday. Advise that right now on your batteries, you have 111 amp-hours; and, eventually, we hope to have them up—peaked up to about 116. One other point, we—we can either read that procedure up again which involves cranking up the telemetry, or, if Jack still has it, we can use his notes and—but I have one or two changes to—to make on them. Over.
- Jim Lovell (CDR)
-
Okay, understand that you'll want us to terminate battery charge for a while, and crank up the CM TM to read out temperatures. And you have a few changes to Jack's checklist, and I'll turn the COMM over here to Jack shortly, as soon as he's finished, and we'll get along with it.
- Vance Brand (CAPCOM)
-
Jim, we have you 101 000 miles out, and your velocity is 5848. Starting to speed up.
- Vance Brand (CAPCOM)
-
That's affirm, Jack. Request to—Before you terminate it, get the usual readout on voltage and current; and we'd also like a time of termination, and understand you have the termination procedures. Is that affirm?
- Jack Swigert (CMP)
-
Okay. That's affirm. Stand by. Let me just make sure I've got everything here before I go off on a tangent.
- Vance Brand (CAPCOM)
-
Okay, Jack, and your battery-charge termination procedure remains unchanged, but when we go to power up the CM and look at your TM, we have a couple of additional steps.
- Jack Swigert (CMP)
-
Okay. Vance, I do have the procedure for stopping the battery charge. And do you want me to copy this procedure now, or do you want me to come back and give you the volt, amps, and time and—after I complete this termination?
- Vance Brand (CAPCOM)
-
Okay. Just—just give us the volts and amps just before you start the termination of the procedure, and understand you say you have the charge—the procedure for taking the charge off. Is that affirm?
- Vance Brand (CAPCOM)
-
Negative. Unless you want me to. I'll tell you what; I could run through it very quickly just to verify that we're getting started off on the correct path here.
- Jack Swigert (CMP)
-
Yes. Okay, the first four or five things that I have is panel BAT CHARGE to OFF on panel 3; AC INVERTER 2, OFF; panel 5: MAIN BUS TIE, BAT A/C ON; panel 250: CB BAT A POWER ENTRY/POSTLANDING, open; panel 275: INVERTER POWER 2, MAIN B, open; and then, the—just to go ahead and reverse the position of the switches and circuit breakers that I started out with, and these don't have to be in reverse order. Is that Charlie?
- Vance Brand (CAPCOM)
-
Never mind, Jack. I'll bring this up later when you've finished the procedure.
Expand selection down Contract selection up - Jack Swigert (CMP)
-
Okay. I'm going off the air; I'll put Fred-o on. I'm going to stop the battery charge.
- Vance Brand (CAPCOM)
-
Hey, loud and clear, Fred. Understand you've been doing some spring housecleaning, moving stowage around up there.
- Fred Haise (LMP)
-
Boy, you wouldn't believe this LM right now; it's nothing but bags from floor to ceiling.
- Vance Brand (CAPCOM)
-
Hey, that brings up a question. We were wondering where you guys plan to stow the probe and drogue? It occurred to us that one possibility was to stow it in the LM, down about where the LMP normally stands, underneath the IS—ISAer. Perhaps you have a better idea. Over.
- Fred Haise (LMP)
-
Yes, I do, Vance. … would go in the LM, but I thought maybe we ought to stow it where the CDR stands. How's that?
- Vance Brand (CAPCOM)
-
Okay. I can tell that you're just getting—getting that one over because Jim just got off the loop.
- Fred Haise (LMP)
-
Yes, he's sleeping. No, that's—that's actually where we normally had been stowing it for normal LM JETTs.
- Vance Brand (CAPCOM)
-
Okay, and—Hey, we just—we'll record that, and figure that you'll stow the probe and drogue over in the—where the CDR stands. We have a—a change to this—equipment transfer list that I just read up to Jim. Why don't you make a note of this one item? Forget about the LM —
- Fred Haise (LMP)
-
I think Jack hauled off the piece of paper with that—all that on it. Why don't you hold it until Jack gets done doing the battery charge?
- Fred Haise (LMP)
-
Okay. And there was one piece of flight data that we needed that we didn't bring along this time.
- Vance Brand (CAPCOM)
-
Yes, when you—when you get off nominal, why you just need scratch paper, don't you?
- Vance Brand (CAPCOM)
-
Okay, and we're recording the time that that was complete. You have two lists there, one is LM to CM equipment transfer and the second list is the reverse. Request you scratch the last item on the first list, which is returning used bags to the CM.
- Vance Brand (CAPCOM)
-
Okay, Jack. Understand you completed securing the battery charge. Now if you are ready to copy, Jack, I would like to give you the two changes that we have to the powerup for the CM procedure. Over.
- Jack Swigert (CMP)
-
Okay, Vance. You say you have some changes in the procedures that I used before to get telemetry and to check out the CSM system?
- Vance Brand (CAPCOM)
-
Yes, that's correct, Jack; they're pretty simple. About halfway through the procedure, we have a step on panel 3, which is POWER AMPL, HIGH; we'd like to change that to POWER AMPL, LOW.
- Vance Brand (CAPCOM)
-
And the next change, Jack, is panel 275. Scratch the step “CB MAIN B, BAT B, close—BAT BUS B, close.”
Spoken on April 16, 1970, 9:26 p.m. UTC (54 years, 8 months ago). Link to this transcript range is: Tweet