Spacelog Apollo 13

Okay.

Houston, Aquarius; how do you read?

I'm hearing you with a lot of background noise, Fred-o.

Aquarius, could you get a—amps and volts readout from Odyssey, please?

Okay. Stand by.

The CMP is dotting across there. You'd be amazed at how proficient you get at transfering to the tunnel after the first 1000 times.

I didn't get your last there, Fred-o. We'd like you to verify that your POWER AMPLIFIER circuit breaker is open.

Okay. That's verified. POWER AMPL breaker is open.

Roger.

Okay, Jack; that's 34.6 volts and just a little bit under 2.5 amps.

Okay, Fred. I copied 2.5 amps. Say again the volts, please.

34.3 and that was just a little bit below 2.5.

34.3; thank you.

Okay. … point …

Fred-o, I didn't copy the last. Say again the voltage, please.

Okay. The volts, 35.0; amps, 2.4.

The weather prediction for your landing area is still good; 2000 scattered, high scattered; 4-foot seas, 15-knots wind. There's a hurricane 500 miles to the west, which doesn't pose a problem.

Aquarius, Houston. We need another readout amps and volts, and that will be our last one for a half hour. Over.

Okay. The reading is 37.8 volts, 2.3 amps.

Say again, Fred.

37.8 volts, 2.3 amps.

37.8 and 2.3. And that will be our last one for a half hour. Thank you. And I'm about to exercise my fifth general order here, and pass it along to Joe.

Aquarius, Houston. Over.

…

Okay. This is your friendly do-it-yourself-kit COMM with a suggested procedure in the lithium hydroxide situation. You're looking good. We read 1.8 millimeters, and you do have sufficient LM … to last you the rest of the flight. However, being on the conservative side, we would like to use one more set of command module canisters to guard against some possible problems with the LM, primary canister. And I have a simplified procedure for doing that, if you want to listen to it now. Over.

Okay. I think I read that you were ready. I forgot … earphones. This simply consists of getting a second pair of cartridges out of the command module, putting one band of sticky tape, that is the gray tape, with the sticky side out, around the sides of each new canister near the top, taking a piece of EVA cue card and cutting it into four squares about 2 or 3 inches on a side, bending those at a right angle to form corner support, attaching them to the sticky tape, so that they'll stick up and overlap the old canister, and then simply putting the old canister next to the new canister and taping it up real good so it sticks together. The only other procedure is to remove the towel plug from the old cartridges and put it in the bottom of the new cartridge. And that's it. Over.

Okay. As I read you we get the gray tape and fold it so that we get—the back sticks around the outside of the canisters, then we mount to that four sides of our … cards like our EVA … cards; then we overlap those cards down around the base of the canister. Then we—then we … over the … at the top. … Then we take the towel from the old ones and put them in the bottom of the new ones. … …

Okay, Fred. I think you got it. I didn't completely copy your readback, but it's just that simple. We're just putting the new cartridge—the top of the new cartridge against the bottom of the old one, moving that towel plug, using the cue cards as little corner stiffeners, and taping her up.

Okay. The top of the new against the bottom of the old.