- Jack Lousma (CAPCOM)
-
13, Houston. We see you getting close to gimbal lock there. We'd like you to bring up all quad Cs on MAIN A, quad C-1, C-2, C-3, C-4 on MAIN A, and also bring B-3 and B-4 up on MAIN A.
- Jack Lousma (CAPCOM)
-
Okay. Can you tell us anything about the venting, where it is coming from, what window you see it at.
- Fred Haise (LMP)
-
It's coming out of window 1, right now, Jack, and could you give me the thrusters again?
- Jack Lousma (CAPCOM)
-
We'd like—on MAIN A, we'd like Charlie 1, 2, 3, and 4. Also Bravo 3 and 4 on MAIN A.
- Jack Lousma (CAPCOM)
-
Okay, 13; this is Houston. We'd like you to go to your G&C checklist, the pink pages, 1-5. Do powerdown until we get a Delta of 10 amps. Over.
- Jim Lovell (CDR)
-
Okay, Jack, say again that—… for the powerdown; it's not in the pink pages, the 1-5.
- Jack Lousma (CAPCOM)
-
Okay. We'd like you to go down that powerdown procedure until you get a Delta of 10 amps. Over.
- Jack Lousma (CAPCOM)
-
That's in your systems checklist, page 1-5.
Expand selection up Contract selection down Close - Jack Lousma (CAPCOM)
-
And, 13, you might also check for those pages in your launch checklist. They're emergency pages; pink pages, 1-5, and we'd like you to power down until you get —
- Jack Lousma (CAPCOM)
-
Roger. Power down until you get an amperage of 10 amps less than what you got now. Over.
- Jack Swigert (CMP)
-
Okay, Jack, and on this page 1-5, we proceeded right down the list, all the way down; we're right now at BMAG number 2 is in WARM UP.
- Jack Swigert (CMP)
-
Okay, and something is giving us a reach, Jack, both in pitch and roll, so I'm suspecting that maybe it's whatever it is that's venting back there. I've had to use DIRECT in order to stabilize this, and as soon as I do, we're starting to pick up rates again. Can you pick up any jets firing?
- Jack Lousma (CAPCOM)
-
13, Houston. We need to get some more instrumentation up. We'd like you to put INVERTER 1 on both AC BUSES. Over.
- Fred Haise (LMP)
-
Okay. Okay, you got INVERTER 1 on both AC BUSES now. And Jack, one of the items that we turned off was the—all the fuel cell pumps. Okay, and you might let us know when fuel cell 2 needs its pump back; we ought to take care of that guy.
- Jack Lousma (CAPCOM)
-
Okay, 13. We've got lots and lots of people working on this; we'll give you some dope as soon as we have it, and you'll be the first one to know.
- Fred Haise (LMP)
-
Okay, Jack, and the weird configuration we're sitting in now is we have the hatch installed, we still have the probe and drogue inside the command module, and we're going to stay in this situation until you—kind of give us an okay to reinstall the probe and drogue.
- Jack Lousma (CAPCOM)
-
13, this is Houston. We'd like to power down just a little bit more, so let's get BMAG 2 OFF; and make sure your lights are down. Over.
- Jack Lousma (CAPCOM)
-
And 13, Houston. We'd like you to turn all your Bravo thrusters OFF; and put all your Delta thrusters on MAIN A, please.
- Jack Lousma (CAPCOM)
-
That's affirmative. And we're trying to get power to that tank. Stand by; we're working on it.
- Jack Swigert (CMP)
-
Let's read you the lights we got on now; CRYO PRESS, FUEL CELL 1, FUEL CELL 3, MAIN BUS B UNDERVOLT, SUIT COMPRESSOR.
- Jack Lousma (CAPCOM)
-
Roger, we copy them and we'd like to build up the pressure in O2 tank 1, so turn the heaters on manually; we'll watch the pressure for you.
- Jack Lousma (CAPCOM)
-
13, Houston. We'd like you to additionally bring on the fans in O2 tank 1, and we can stand the additional amperage on that.
- Jack Lousma (CAPCOM)
-
13, Houston. We'd like you to check some circuit breakers on panel 226. CRYO O2 HEATER number 1 MAIN A, and check the three CRYO FAN MOTORS, TANK 1, three phases.
- Fred Haise (LMP)
-
Okay, Jack. 226 is configured just like it should be. I got three REACS breakers and three RAD breakers open. All the rest are closed.
- Jack Swigert (CMP)
-
Jack, looking outside, the number of particles has diminished greatly, almost ceased now, which indicates maybe what was venting has almost stopped.
- Jack Lousma (CAPCOM)
-
13, this is Houston. We'd like you to give us a survey of your displays on MDCs 1 and 2. Give us gage readings and talkbacks. Over.
- Jack Swigert (CMP)
-
Okay, Jack. On MDC 1, there's nothing abnormal. All the rate indicators are zero. Ball number 2 is frozen, of course; we lost MAIN B. I've got—Ball number 1 appears to be working normally. Right now I'm sitting at roll 0, pitch 180, and yaw about 13 degrees. I'm going to try and hold 0, 180, and 0.
- Jim Lovell (CDR)
-
Okay, Houston. The center panel—I'm looking at the RCS indicator A. We have a package temperature of about 180. Our helium pressure is 3900. I'm looking at fuel pressure of about 180 and percentage of about, I'd say 85 percent. B is about the same, except that that package pressure is 190. On quad C, we're looking about the same, except that the package temperature is 100. On quad D, we're looking at package temperature of 160. All other indications are about the same. CM pressure—RCS pressure is looking nominal. Helium pressure's up around 4000. And package temperature is about—a little less than 80 on ring 1 and about the same on ring 2.
- Jim Lovell (CDR)
-
And the—talkbacks on the SM RCS, I've got HELIUM 1 now are all gray. HELIUM 2 are all gray. PRIMARY PROPELLANT all gray. SECONDARY PROPELLANT, I've got two barber pole, and A is barber pole, B gray, C barber pole, and D gray. Okay. On the ECS RADIATORS, barber pole is gray. On the—On the ECS, PRIMARY INDICATOR.
- Fred Haise (LMP)
-
Okay, Jack. Starting at the top. Okay. The CRYO TANKS; H2 1 is reading 230 and the same for 2. Our O2 CRYO TANK 1 is—looks like it's barely holding its own at 300. And, CRYO TANK 2 is reading zip. Our quantities: H2 1 is reading 73, 2, 74. On the O2 side, we're reading O2 1 at quantity, 76; O2 pegged to full scale high. RAD TEMPs PRIMARY INLET, we're reading about 55; RAD OUT is reading about 30, and the SECONDARY OUTLET is reading—reading 52 degrees. And the EVAP OUT TEMP is 45, STEAM PRESSURE 0.17, and GLYCOL DISCHARGE 48. SUIT COMPRESSOR is reading zip. The ACCUM is reading 30; H2O WASTE is reading about 34; POTABLE's reading about 98; SECONDARY RAD INLET is reading about 71; and the RAD OUT is about 30; GLYCOL EVAP TEMP is reading 65, STEAM PRESSURE pegged full scale high; DISCHARGE PRESSURE 9 psi.
- Jack Lousma (CAPCOM)
-
Excuse me, Fred; I'd like to butt in here a minute. We'd like to have THRUSTER C-1 off.
- Fred Haise (LMP)
-
Okay —
Expand selection down Contract selection up - Fred Haise (LMP)
-
Okay. Your SECONDARY RAD IN, I gave to you 70—about 72 degrees; the RAD OUT is about 30; the GLYCOL EVAP TEMP is reading about 65; STEAM PRESSURE full scale high, GLYCOL DISCHARGE PRESSURE about 9 psi. The ACCUM—SECONDARY ACCUMULATOR is about 30—34 percent. Our temperatures: SUITS showing about 52 degrees; CABIN about 58 degrees; pressures, SUIT reading 4.1, CABIN at 5. PARTIAL PRESSURE CO2 is up to little over 1, about 1.1. On the SPS side of the house, the temperature is 72 degrees, helium's reading 3500; N2 A is reading 2300; N2 B about 2450. And our ullage pressures: FUEL is reading about 165; OXIDIZER 170. Fuel cells: FUEL CELL 1, both CLOSED, they're zip; SKIN TEMP 405 degrees; CONDENSE EXHAUST is lower scale. FUEL CELL 2—right now we've got an O2 or an H2 FLOW reading of 0.13 to 0.14, and the O2 FLOW is right now pegged full scale high although it has been varying depending on thruster activity which has also given us MAIN BUS A under volts from a steady reading of about 1.1 up to full scale high. The TSKIN is about 445 and the CONDENSOR EXHAUST 17, correction, 180. Let's see if you want it on the DC indicator: FUEL CELL 1 is 0 amps; 2 is reading somewhere between 44 and about—oscillating 44 to 48 again depending on thruster activity.
- Jack Lousma (CAPCOM)
-
Okay, 13. This is Houston. It appears to us that we're losing O2 flow through fuel cell 3. So, we want you to close the REAC valve on fuel cell 3. It looks like fuel cell 1 and 2 are trying to hold up okay. You copy?
- Fred Haise (LMP)
-
Are you saying fuel cell 1 and 2—1 and 2 are trying to hold up but we're leaking O2 out of fuel cell 3? And you want me to shut the REAC valve on fuel cell 3? Did I hear you right?
- Fred Haise (LMP)
-
Okay. I'll go to the SSR page. Do you want me to go through that whole smash for fuel cell shutdown? Is that correct?
- Jack Lousma (CAPCOM)
-
Okay, 13. We want you to turn the inline heaters off on fuel cell 1. Then we want you to go through the fuel cell shutdown procedure on fuel cell 3. Read back.
- Jack Swigert (CMP)
-
Okay. Shut down the inline heater on fuel cell 1. We're proceeding with the shutdown, special subroutine, for fuel cell 3.
- Jack Lousma (CAPCOM)
-
Okay. You got OMNI Bravo and we'd like to have you verify that the tape recorder is off please.
- Jack Swigert (CMP)
-
That's verified. Okay, Jack. I'm sitting here with an 0618 showing and I can't get rid of it. Oh, stand by just a —
- Jack Swigert (CMP)
-
Okay, Jack. Step 2, special subroutine 1 for the fuel cell procedure, has been completed.
- Jack Swigert (CMP)
-
Okay. Jack. I'd like to bring on jet A-4. I've got null on negative pitch control, and—negative pitch control, and right now neither DIRECT or AUTO coils.
- Jack Lousma (CAPCOM)
-
And, Fred, we would like to have you verify fuel cell reactants talkback is barber pole.
- Jack Swigert (CMP)
-
Okay. Jack. Let me give you a thruster configuration right now. Able 1, Charlie 1, Able 2 are off. Charlie 2, MAIN A, all the thrusters that I call that are on are on MAIN A. Baker 1 off. Dog 1 on, Baker 2 off, Dog 2 on. Able 3, Charlie 3, Able 4, Charlie 4 on. Baker 3 off, Dog 3 on, Baker 4 off, Dog 4 on.
- Jack Swigert (CMP)
-
All right. Okay. Do you want some readings from the systems test meter regarding fuel cells?
- Jack Lousma (CAPCOM)
-
Okay, 13. We'd like to have you give us those systems test readings on fuel cell 1 and 3, please.
- Fred Haise (LMP)
-
Okay. Jack, 1-A is reading, lower scale, 0; 1-B is reading. 3.45. Okay. You only want fuel cells 1 and 3. Okay. Ignore that 1-B reading. 1-C is reading 3.4. Now, 1-D is reading 2.4. 2-D is reading 0.25.
Spoken on April 14, 1970, 3:31 a.m. UTC (54 years, 8 months ago). Link to this transcript range is: Tweet